超声波/零价铁协同体系作用机理探讨

在超声波/零价铁协同体系中,探讨了OH.的产生途径及其影响因素,并分析了Fe0表面形态变化。结果表明:在超声波/零价铁体系中,羟基自由基的产生途径主要有四种:声空化导致水分子热解、Fenton反应、超声波与类Fenton反应的复合效应、铁粉颗粒效应;pH值过低或过高都不利于羟基自由基产生;当铁粉投加量为2.0g/L时最有利于羟基自由基产生;超声波通过冲刷、碎裂、清洗、气蚀和熔合等多种效应,活化和增强铁粉的表面性能。     

节能型虹吸式滗水器的设计与应用

详细介绍了虹吸式滗水器的构成、特点及工作原理,结合理论和实践经验给出了虹吸式滗水器的设计、计算方法及关键设计参数,提出了常规使用方法,整套设备的设计全面而简单明了。     

聊城市城市地表径流污染负荷估算

基于ArcGIS软件,依据土地利用、土壤类型等遥感数据生成聊城市东昌府城区的土地利用图,统计不同土地利用类型的面积,将研究区域按不同功能分为居住区、交通区、工业区、绿化用地、公共建设用地和未利用土地,选择不同CN(Curve Number)值,采用SCS径流曲线模型计算2009年的径流深度和年径流量。结果表明:聊城市东昌府区2009年不同功能分区的降水径流深度分别为272.47 mm、465.00 mm、277.16 mm、30.68 mm、128.47 mm、167.51 mm,同时,根据研究区域内悬浮物(SS)、化学需氧量(COD)、总氮(TN)、总磷(TP)等污染物的平均浓度,估算得出它们的负荷量分别为8 558.8 t、2 415.32 t、201.29 t、10.08 t。     

酵母菌在环境污染治理中的应用与进展

酵母菌是一种珍贵的微生物资源,由于它具有良好的耐酸、耐渗透压、产生单细胞蛋白等特点,广泛地应用于环境污染治理中。文章概括了酵母菌处理各类废水的方法、在废弃物资源化利用发挥的作用以及酵母菌对污染土壤的修复作用,指出随着酵母菌研究的深入和其它相关技术的开发,酵母菌在环境污染治理中得到更广泛、更深入的应用,实现环境、社会和经济等可持续发展。     

响应曲面法优化物理活化制备羊骨基活性炭工艺

为通过物理活化法制备羊骨活性炭,采用响应曲面(Response surface methodology,RSM)实验设计,以活化温度、活化时间、CO2流量为试验因素,以碘吸附值为响应值,建立数学模型,工艺条件进行优化。结果表明:最佳工艺条件为活化温度476.05℃、活化时间9.34 min、CO2流量159.4 mL/min,在此条件下碘吸附值为411 mg/g;通过对碘吸附值曲面方程和二次多项回归方程解逆矩阵得知该方程的预测值与实际值之间具有较好的拟合度。     

厌氧序批式反应器预处理垃圾渗滤液的碳平衡研究

为初步了解垃圾渗滤液中有机物降解过程的物质和能量转化,对渗滤液实际处理工程提供借鉴,在最优工艺参数条件下,分别用处于中温(35±1)℃和常温状态的厌氧序批式反应器(ASBR)对垃圾渗滤液进行预处理。通过对反应器内的液相、气相和固相碳素进行全面的分析测定,结果表明:中温(常温)条件下,整个反应周期内约有86.4%(77.6%)的碳进入气相,约有1.7%(1.4%)的碳进入固相,其余约11.7%(22.3%)的碳仍存于液相中;其中,进入气相部分的碳有77.6%(71.3%)以甲烷形式存在,8.8%(4.7%)以二氧化碳形式存在,这说明ASBR预处理垃圾渗滤液过程中产生的甲烷资源化利用潜力较大。另外,反应器在中温状态下较常温状态处理效果更佳。     

基于响应曲面法袋式除尘器清灰性能的数值研究

利用计算流体动力学（CFD）方法,采用二维、可压缩、非稳态流动数学模型,对袋式除尘器脉冲喷吹过程中滤袋内的清灰流场进行了数值模拟,比较了滤袋壁面压力峰值的模拟值和试验值.同时,利用该模型,基于响应曲面法并使用统计软件MinitabV15研究了喷嘴直径、喷吹高度、文丘里管喉管直径、文丘里管及布袋长度对袋式除尘器清灰性能的影响,并得出了这5个影响因子的二次多项式预测模型.结果表明,滤袋表面压力峰值的模拟值与试验值变化趋势基本上是一致的,误差在10%左右,从而验证了本文数值计算模型的可靠性.在上述5个影响因素中,喷嘴直径（d）、文丘里管喉管直径（de）及布袋长度（L）对清灰性能影响显著,其中,清灰性能随着喷嘴直径和文丘里管喉管直径的增大而提高,随着布袋长度的增大先提高后降低.在本文所研究的尺寸范围内,当d=20mm、de=60mm及L=3360mm时,清灰效果分别达到最优.所得结论有助于进一步改善袋式除尘器的清灰性能.     

萘降解菌MQ合成靛蓝的研究

利用萘降解菌(丛毛单胞菌)MQ完整细胞对吲哚进行转化合成靛蓝,结果表明菌株MQ具有较好的靛蓝合成能力,靛蓝产量在4h左右即达到稳定.薄层色谱和高效液相色谱分析结果表明,合成的蓝色产物为靛蓝.考察了反应温度及摇床转速对靛蓝合成的影响,结果表明最适温度和转速分别为25℃和150r·min-1.随后,采用表面响应法确定了菌株MQ合成靛蓝的最优条件:菌株接种量OD6602.16,吲哚浓度200.55mg·L-1,pH=6.91.在最优条件下,菌株MQ合成靛蓝的产量为53.05mg·L-1,比初始条件下的产量提高了179%.     

Optimum conditions for the formation of Al13 polymer and active chlorine in electrolysis process with Ti/RuO2-TiO2 anodes

A polyaluminum containing a high concentration of Al₁₃ polymer and active chlorine (PACC) was successfully synthesized by a new electrochemical reactor using Ti/RuO₂-TiO₂ anodes. PACC can potentially be used as a dual-function chemical reagent for water treatment. The obtained results indicated that the formation of Al₁₃ polymer and active chlorine, were the most active components in PACC responsible for coagulation and disinfection respectively. These components were significantly influenced by electrolyte temperature, current density, and stirring rate. It was observed that high electrolyte temperature favored the formation of Al₁₃. Increasing current density and stirring rate resulted in high current efficiency of chlorine evolution, thus favoring the generation of Al₁₃ and active chlorine in PACC. When the PACC (Al_T = 0.5 mol/L, basicity = 2.3) was prepared at the optimum conditions by electrolysis process, the Al₁₃ polymer and active chlorine in product reached above 70% of Al_T and 4000 mg/L, respectively. In the pilot scale experiment with raw polyaluminum chloride used as an electrolyte, PACC was successfully prepared and produced a high content of Al₁₃ and active chlorine products. The pilot scale experiment demonstrated a potential industrial approach of PACC preparation.     

Determination of ammonium on an integrated microchip with LED-induced fluorescence detection

A simply fabricated microfluidic device integrated with a fluorescence detection system has been developed for on-line determination of ammonium in aqueous samples. A 365-nm light-emitting diode (LED) as an excitation source and a minor band pass filter were mounted into a polydimethylsiloxane (PDMS)-based microchip for the purpose of miniaturization of the entire analytical system. The ammonium sample reacted with o-phthaldialdehyde (OPA) on-chip with sodium sulfite as reducing reagent to produce a fluorescent isoindole derivative, which can emit fluorescence signal at about 425 nm when excited at 365 nm. Effects of pH, flow rate of solutions, concentrations of OPA-reagent, phosphate and sulfite salt were investigated. The calibration curve of ammonium in the range of 0.018-1.8 μupg/mL showed a good linear relationship with R² = 0.9985, and the detection limit was (S/N = 3) 3.6 × 10^-4 μupg/mL. The relative standard deviation was 2.8% (n = 11) by calculating at 0.18 μupg/mL ammonium for repeated detection. The system was applied to determine the ammonium concentration in rain and river waters, even extent to other analytes fluorescence detection by the presented device.